Cabletron Systems SmartSwitch Router User's Reference Manual page 220

Chapter 13: IP Policy-Based Forwarding Configuration Guide
Display information about all
IP policies on a specified
interface.
Display information about IP
policies that have been applied
to all interfaces
Clear statistics gathered for IP
policies.
For example, to display information about an active IP policy called "p1", enter the
following command in Enable mode:
ssr# ip-policy show policy-name p1
--------------------------------------------------------------------------------
IP Policy name
Applied Interfaces : int1
Load Policy
4
ACL Source IP/Mask
--- --------------
prof1 9.1.1.5/32
prof2 2.2.2.2/32
everything anywhere
11 12 13
Seq Rule ACL
--- ---- --------
10 permit prof1
20 permit prof2
999 permit everything 0
65536 deny deny
21
Legend:
1. The name of the IP policy.
2. The interface where the IP policy was applied.
3. The load distribution setting for IP-policy statements that have more than one next-
hop gateway; either first available (the default) or round-robin.
4. The names of the profiles (created with an acl statement) associated with this IP
policy.
220
: p1
1
2
: first available
5 6
Dest. IP/Mask
-------------
15.1.1.2
anywhere
anywhere
14 15
Cnt Action
--- -----------
0 Policy Only
0 Policy Last
Policy Only
0 N/A
ip-policy show interface
ip-policy show interface all
ip-policy clear all|policy-name
3
7
SrcPort
--------- --------- --- ----
any
any
any
Next Hop Information
--------------------
16
Next Hop
--------
11.1.1.2
1.1.1.1
2.2.2.2
3.3.3.3
drop
normal fwd
SmartSwitch Router User Reference Manual
<interface>
<name>
|all
8 9 10
DstPort TOS Prot
any 0 IP
any 0 IP
any 0 IP
17 18
Cnt Last
--- ----
0 Dwn
0 Dwn
0 Dwn
0 Dwn
N/A N/A
N/A N/A