Creating Rmon Cli Filters; Using Rmon Cli Filters; Troubleshooting Rmon - Cabletron Systems SmartSwitch Router User's Reference Manual

Creating RMON CLI Filters

To create RMON CLI filters, use the following CLI command in Configure mode:
Creates an RMON CLI filter.

Using RMON CLI Filters

To see and use RMON CLI filters, use the following CLI command in User or Enable
mode:
Displays RMON CLI filters.
Applies a CLI filter on current
Telnet or Console session.
Clears the currently-selected
CLI filter.

Troubleshooting RMON

If you are not seeing the information you expected with an rmon show command, or if the
network management station is not collecting the desired statistics, first check that the
port is up. Then, use the rmon show status command to check the RMON configuration
on the SSR.
SmartSwitch Router User Reference Manual
Chapter 21: RMON Configuration Guide
rmon set cli-filter
rmon show cli-filters
rmon apply cli-filters
rmon clear cli-filter
<filter-id> <parameter>
<filter-id>
311