Creating An Ipx Rip Access Control List; Monitoring An Ipx Network; Configuration Examples - Cabletron Systems SmartSwitch Router User's Reference Manual

Chapter 16: IPX Routing Configuration Guide

Creating an IPX RIP Access Control List

IPX RIP access control lists control which RIP updates are allowed. To create an IPX RIP
access control list, perform the following task in the Configure mode:
Create an IPX RIP access control list.
Once an IPX RIP access control list has been created, you must apply the access control list
to an IPX interface. To apply an IPX RIP access control list, enter the following command
in Configure mode:
Apply an IPX RIP access control list.

Monitoring an IPX Network

The SSR reports IPX interface information and RIP or SAP routing information.
To display IPX information, enter the following command in Enable mode:
Show a RIP entry in the IPX RIP table.
Show a SAP entry in the IPX SAP table.
Show IPX interface information.
Show IPX RIP table.
Show IPX routing table.
Show IPX SAP table.
Show IPX RIP/SAP table summary.

Configuration Examples

This example performs the following configuration:
• Creates IPX interfaces
• Adds static RIP routes
• Adds static SAP entries
• Adds a RIP access list
252
<name>
acl permit|deny ipxrip
<FromNetwork> <ToNetwork>
<name>
acl apply interface
<Interface Name>
[logging [on|off]]
<DstNetwork>
ipx find rip
<type> <ServiceType>
ipx find sap
<ServiceName> <ServerNetwork>
ipx show interfaces
ipx show tables rip
ipx show tables routing
ipx show tables sap
ipx show tables summary
SmartSwitch Router User Reference Manual
input|output
<interface-name>