Creating An Aggregate Destination; Creating An Aggregate Source; Examples Of Import Policies; Example 1: Importing From Rip - Cabletron Systems SmartSwitch Router User's Reference Manual

Chapter 11: Routing Policy Configuration Guide

Creating an Aggregate Destination

To create an aggregate destination, enter the following command in Configure mode:
Create an aggregate
destination.

Creating an Aggregate Source

To create an aggregate source, enter the following command in Configure mode:
Create an aggregate source.

Examples of Import Policies

Example 1: Importing from RIP

The importation of RIP routes may be controlled by any of protocol, source interface, or
source gateway. If more than one is specified, they are processed from most general
(protocol) to most specific (gateway).
RIP does not support the use of preference to choose between routes of the same protocol.
That is left to the protocol metrics.
For all examples in this section, refer to the configuration shown in
182
ip-router policy create aggr-gen-dest
<ipAddr-mask>
network
ip-router policy create aggr-gen-source
<protocol-name>
protocol
SmartSwitch Router User Reference Manual
<name>
<name>
Figure 17 on page 183.