Configuring Dvmrp On An Interface; Configuring Dvmrp Parameters; Configuring The Dvmrp Routing Metric - Cabletron Systems SmartSwitch Router User's Reference Manual

To start or stop DVMRP, enter one of the following commands in Configure mode:
Start DVMRP.
Stop DVMRP.

Configuring DVMRP on an Interface

DVMRP can be controlled/configured on per-interface basis. An interface does not have
to run both DVMRP and IGMP together. DVMRP can be started or stopped; IGMP starts
and stops automatically with DVMRP.
To enable IGMP on an interface, enter the following command in the Configure mode:
Enable DVMRP on an
interface.

Configuring DVMRP Parameters

In order to support backward compatibility, DVMRP neighbor timeout and prune time
can be configured on a per-interface basis. The default neighbor timeout is 35 seconds.
The default prune time is 7200 seconds (2 hours).
To configure neighbor timeout or prune time, enter one of the following commands in
Configure mode:
Configure the DVMRP neighbor
timeout.
Configure the DVMRP prune time.

Configuring the DVMRP Routing Metric

You can configure the DVMRP routing metric associated with a set of destinations for
DVMRP reports. The default metric is 1.
To configure the DVMRP routing metric, enter the following command in Configure
mode:
Configure the DVMRP routing
metric.
SmartSwitch Router User Reference Manual
Chapter 12: Multicast Routing Configuration Guide
dvmrp start
no dvmrp start
dvmrp enable interface
dvmrp set interface
timeout
dvmrp set interface
<number>
dvmrp set interface <ip-addr> metric <number>
<ipAddr>|<interface-name>
<ip-addr>
neighbor-
<number>
<ip-addr>
prunetime
203