Cooling Liquid Preparation; Chips Disposal - Bomar Ergonomic Series Operating Instructions Manual

4.5.2.
4.5.3.
74

Cooling liquid preparation

Prepare a mixture of water and cooling liquid. Conform the notes of the
manufacturer and keep the manufacturer's-approved concentration
All instructions are stated on the tank of the cooling liquid or in documentation of
the cooling liquid. For cooling liquid usage and disposal heed the instructions of the
manufacturer.
Fill the mixture of water and cooling liquid to the tank of the cooling system
When filling the tank with the cooling liquid take care that the liquid will not drip
out of the tank and the tank does not overflow
Keep to the manufacturer specified recommendations for adding the anticorrosive
agents, the antifreeze or other agents! Mixing two chemicals can produce toxic and
aggressive substances, which can damage your health or the cooling system of the
machine
Note: If the machine is equipped with Microniser (see. Special accessory), fill the
tank of the Microniser with specified cooling liquid. Then the microniser is ready for
the operation
The quality of the cooling agent will deteriorate due to:
use of contaminated water

impurities

outside oil contamination (hydraulics, gears)

high operating temperatures

lack of air circulation

wrong concentration

If the solution is too weak:
corrosion protection is diminished

lubrication decreases

microbial attack is more likely

If the solution is too strong:
the cooling ability is decreased

foam behavior increases

emulsions stability deteriorates

sticky residue develops


Chips disposal

Chips resulting from cutting operations must be disposed of in accordance with the
relevant regulations.
Let the chips drip excess fluid!

Put the chips into a watertight container. Make sure that the container does

not leak, because even after a long dripping time, the chips still contain
coolant residues.
Manual version: 1.03/ May 2016
Manual rev.: 1