4.4.6.
4.4.7.
72
Saw frame lower position stop adjustment
The lower stop limits the lowest position of the saw frame. This stop has to be
checked at least once a month. If the lower stop is adjusted incorrectly, the loading
surface of the table can be cut too deeply or the material will not be cut completely
1.
Raise the saw frame to the upper position
2.
Release the nut of the adjusting screw and adjust the stop
3.
Fasten the adjusting screw with the nut again
4.
Set the limit switch of the lower arm position
Adjustment of the limit switch of saw frame lower stop
If you have adjusted the lower stop of the saw frame, the limit switch adjustment
inspection is required
Setting check
Lower the arm to the lowest position. If the arm lays on the lower stop and the
switch reacts, the setting is correct. In other case carry out the switch setting
Switch setting
Manual version:
1.03/ May 2016
Manual rev.:
1