Setting Of The Material Length - Bomar Ergonomic Series Operating Instructions Manual
Hide thumbs
Also See for Ergonomic Series:
- Operating instructions manual (82 pages) ,
- Operating instructions manual (189 pages) ,
- Operating instructions manual (86 pages)
Table of Contents
Advertisement
3.3.2.
52
Setting of the material length
1.
Loosen the clamping screw of the length stop
2.
Shift the length stop to the required length and tighten the clamping screw.
Warning!
The length stop enables a gap between the length stop slat
line and the material to avoid clenching the saw band in
the cut during cutting. Set the gap of the length stop by
turning the lever in the direction of the arrow.
Manual version:
1.03/ May 2016
Manual rev.:
1
Advertisement
Table of Contents
