Safety Notes For Machine Operator - Bomar Ergonomic Series Operating Instructions Manual

Operate the machine only when you are fit enough to work. Illnesses or injuries
diminish concentration. Avoid machine work, which may compromise the safety of
you and your colleagues!
Attention!
Mind the safety signs on the machine. Do not remove or
damage them!
Attention!
Machine can be operated by person older than 18 years!
Machine can be operated only by a person physically and
mentally fit for this activity
Follow the instructions and orders about work safety!
Read the operating instructions, before you start to work on
the machine! Keep the operating instructions in good
condition!
1.3.

Safety notes for machine operator

Machine can be operated only by one person. Machine operator is responsible for
other people present near the machine.
Close covers before starting the machine and check, if the covers are not damaged.
Damaged covers must be repaired or changed immediately. Do not start the
machine, if the cover is removed! Check, if the electric cables are not damaged.
Do not hold the material for clamping in the vice and when cutting!

Do not operate the buttons and switches on the control panel, when you have

gloves!
Attention!
Do not connect the machine to electricity if the covers
are removed. Do not touch the electrical equipment or
wiring.
For machine starting take care, that there is nobody in the working area of the

machine (the working area of the vice, the saw band, the saw arm etc.).
Under no circumstances touch the rotating elements.

Work on the machine only when the machine is in good condition!

Check at least once in a shift, if the machine is not damaged. If the machine is

damaged, you must bring the machine to a halt and inform your superior!
Keep your working area clean! Ensure sufficient lighting in the working area.

Take off the spilt water or the oil from the floor and dry it. Do not touch the

cooling liquid with bare hands! Do not set the nozzle of the cooling liquid,
when the machine is started running.
Do not remove the chips from the working area of the machine, when the

machine is running!
15