Adjusting The Limit Switch Of The Saw Band Stretching - Bomar Ergonomic Series Operating Instructions Manual

2. Adjust the brush to the saw band. Its ends must not reach the saw band teeth
bottoms.
3. Tighten the screw again and turn on the band driver. If the chip removing
brush is correctly fastened the brush turns smoothly with the saw band.
Do not tighten the screw with brute force!
Attention!
Do not tighten the screw with brute force!
4.4.5.

Adjusting the limit switch of the saw band stretching

After the saw band is replaced, the limit switch setting must be checked. If the limit
switch is not set correctly, the band is stretched either too much or too little.
1. Stretch the band with help of the TENZOMAT to an optimal value (Tenzomat
chart)
2. Release the nut on the stop screw
3. Start the band drive. Two scenarios may occur:
a) If the engine is switched on, but it does not run, turn the screw to the left
until the engine starts to run
b) If the engine runs turn the screw to the right until it stops, then turn the
screw shortly to the left until the engine starts running again
4. Lock the stop screw using locking nut and check the adjusting of the limit
switch again
71