Setting Of The Cutting Angle - Bomar Ergonomic Series Operating Instructions Manual

3.3.3.

Setting of the cutting angle

The band saw Ergonomic 340.278 DG allows cutting under angles from -45° to 60°.
For an easier setup of common angles, there are latches on the turning console at
every 15° angle increment. Locking in the latches can be felt when turning the saw
frame by hand. It is not necessary to loosen the latches for setting a different angle,
just turn the saw frame console in the direction required.
Picture Procedure
13. Raise the saw frame and
loosen the turning console
clamping lever.
14. Set the required angle of the
cut according to the scale on
the turning console.
15. Tighten the clamping lever of
the console.
53