3.3.
3.3.1.
50
Machine control
Cutting
1.
Open the main vice of the band saw.
2.
Set the length stop to the desired length of the material.
3.
Set the desired cutting angle.
4.
Insert the material and push it to the length stop.
5.
Move the vice jaw to about 5 mm from the material
For a longer distance movement of the vice jaw use the rapid shift option:
a) loosen the arresting lever of the moveable jaw of the main vice
b) move the jaw to the required distance
c) tighten the arresting lever
Manual version:
1.03/ May 2016
Manual rev.:
1