Safety Notes For The Servicing And Repairs; Safety Notes For The Servicing And Repairs On Hydraulic Unit; Safety Notes For The Cooling; Instructions For First Aid - Bomar Ergonomic Series Operating Instructions Manual

1.4.

Safety notes for the servicing and repairs

Switch off the main switch and lock it, before you start service work! Otherwise,
there is a possibility of starting the machine accidentally.
Only qualified person can do the servicing and repairs. For parts replacement, use
only those, which are identical with the originals. Otherwise, there is possibility of
health hazard. Use only recommended types of hydraulic oils, oils and lubricants!
Attention!
Only a qualified professional can carry out the servicing
and repairs of the electrical equipment! Take special care
during the work with electrical equipment. High voltage
shock can have fatal consequences! Always follow the work
safety instructions! Otherwise, there is possibility of heavy
injury!
Do not remove lock the limit switches or safety equipment! Any use of the saw,
accessories or machine parts other than that intended by the BOMAR, spol. s r.o.
company is not permitted. The guarantee on this product will be lost afterward and
BOMAR, spol. s r.o. takes no responsibility for damage caused.
1.4.1.

Safety notes for the servicing and repairs on hydraulic unit

Compliance with the principles of cleanness is a basic requirement for trouble-free
operation of hydraulic equipment. Hydraulic components are products made with
high precision, and any contamination leads to a reduction of lifetime and even
malfunction. The consequences are very difficult and expensive to remove.
Always use clean tools. Never put parts and fasteners which are a part of the
hydraulic circuit on a dirty surface. The best cleaning agent is crepe paper. The
fibers of the cleaning cloths can also cause malfunction.
Remove the protective caps from the threaded chamber just before the assembly
of the unit.
Flush hoses and pipes before mounting with gasoline or other cleaning agent and
blow compressed air through them.
All fittings must be properly tightened. However, do not use brute strength.
Attention!
When handling the coolant always keep to the work

safety directives and instructions of the manufacturer.
When handling cooling agents always wear safety

fluid-proof gloves!
Wear protective goggles!

Cooling liquid can get in contact with your eyes and

may cause permanent severe injuries
1.5.

Safety notes for the cooling

1.5.1.

Instructions for first aid

1. Pull off and safely remove polluted, soaked clothing.
2. If inhaled, go out on fresh air or look for first aid treatment.
17