Saw Band Installation - Bomar Ergonomic Series Operating Instructions Manual

4.2.
64

Saw band installation

1. Prior to installation, clean the track wheels, guiding cubes and inner side of the
arm thoroughly of all traces of chips and dirt. Keep in mind the teeth direction
when installing the saw band.
2. Insert a new saw band in the guide cubes. Make sure the saw band runs
between both guiding rollers and that it is pushed all the way to the top.
3. Put the saw band on both guiding wheels. Make sure that the saw band ridge
fits tightly to the wheel rim. Push the saw band as close to the rim as possible..
4. Turn the tightening star to the right until you gently stretch the band. Now you
can remove the plastic cover on the saw band.
Manual version: 1.03/ May 2016
Manual rev.: 1