Transportation And Stocking; Conditions For Transportation And Stocking; Transport And Stocking Preparations; Transport And Stocking - Bomar Ergonomic Series Operating Instructions Manual

2.4.
2.4.1.
2.4.2.
2.4.3.
32

Transportation and stocking

Conditions for transportation and stocking

Follow the recommendations of the manufacturer for transportation and stocking! If
the recommendations are not kept, damage may occur to the machine.
Don't use a forklift truck for handling the machine, if you do not have

a license for it!
Don't move under suspended loads! Fault in the lifting device may cause

serious injury.
Keep a safe distance from the machine during transport.

Temperature of the air must be between ­25°C and 55°C, for a short period

(max. 24 hours) up to 70°C.
Do not expose the machine to radiation (microwave radiation, ultraviolet

radiation, laser radiation, x-ray radiation). Radiation can cause problems with
the machine function and deteriorating of the condition of the insulation.
Take measures, to prevent damage by dampness, by vibrations and by shakes.


Transport and stocking preparations

Close the vice and thoroughly oil all smooth surfaces.
Lower the saw frame to the lowest position.
Make sure to empty the machine of all traces of the cooling agent.
Fasten all loose parts securely to the machine.
Pack and wrap the control desk securely to avoid damage during transport.
Put the stickers stating the minimum approximate machine weight to at least five
well visible places.
The machine has to be screwed to a pallet for the transportation. Make sure the
pallet is strong enough to be able to hold the saw!

Transport and stocking

The machine must be secured during transportation. Screw the pallet to the floor of
the vehicle. Be careful that the machine is not damaged during transportation.. It is
forbidden to handle the machine in any way different from that written in these
operating instructions, the machine can be damaged.
Store the machine only under conditions mentioned in the manual, to avoid
damage of the machine
Manual version: 1.03/ May 2016
Manual rev.: 1