•
The saw band runs on the wheel rim – The saw band and wheel rim can be
damaged
1.
Start and stop saw band drive.
2.
Stop the main switch!
3.
Open rear cover of the saw frame.
4.
Check saw band placing on the wheels.
•
If the distance of the rear part of the saw band from wheel rim is 1 – 3 mm, setting
is right.
•
If the distance is bigger than 3 mm, or the saw band runs on the wheel rim, saw
band run must be set.
4.4.2.
Saw band setting
The saw band run is set with screw in the stretching cube on the saw frame. Optimal
distance has been determined at 1 – 3 mm.
•
Turn by screw to the right, the saw band approximates to the stretching wheel
rim.
•
Turn by screw to the left, the saw band departs from the stretching wheel rim.
Check saw band run again after setting.
4.5.
Saw frame lower stop position adjustment
The lower stop limits the lowest position of the saw frame. This stop point has to be
checked at least once a month. If the lower stop point is incorrectly adjusted, the
cutting table can be damaged or the material will not be cut completely
43