Table of Contents
Advertisement
4.6.
4.6.1.
4.6.2.
44
1.
Lift the saw frame to the top position.
2.
Release the nut of the screw and set it to the desired value.
3.
Secure the screw with nut.
4.
Set the limit switch of the saw frame lower position.
Limit switch of the saw frame lower position adjustment
If the lower stop of the saw frame was set, the limit switch must be set again.
Check setting
Lower the saw frame to the bottom position. If the saw frame is on the lower stop and
the limit switch was responded, the limit switch adjustment is right. If the limit switch is
not right, it must be set.
Limit switch setting
1.
Release the nut of the stop screw of the switch and screw on the screw.
2.
Lower the saw frame to the lower stop. Start the saw band drive.
3.
Screw off the stop screw of the switch, until the saw band drive is not stopped.
4.
Secure the screw with the nut and check limit switch adjustment again.
Manual version:
1.02 / Nov. 2011
Manual rev.:
1
Advertisement
Table of Contents
