Table of Contents
Advertisement
Do not remove or do not lock the limit switches or safety equipments! Any use of the
saw, accessories or machine parts other than that intended by the BOMAR, spol. s r.o.
company is not permitted. The guarantee on this product will be afterward lost and
BOMAR, spol. s r.o. takes no responsibility for caused damages.
1.5.
Safety notes for the servicing and repairs on hydraulic unit
Compliance with the the principles of cleanliness is basic requirement for trouble-free
operation of hydraulic equipment. Hydraulic components are products made with high
accuracy, and any contamination leads to a reduction lifetime or even malfunction. The
consequences are very difficult to remove and expensive.
Always use clean tools. Parts and fasteners, which are part of a hydraulic circuit, never
put away the dirty surface. The best cleaning agent is crepe paper, because the fibers of
the cleaning cloths can also cause malfunction.
Protective cap from the threaded chamber remove just before the assembly of the unit.
Hoses and pipes before mounting flush with gasoline or other cleaning agent and blow
compressed air.
All fittings must be properly tightened. However, do not raw power.
1.6.
Safety machine accessories
The machine is equipped with safety accessories. It protects the operator from injuries
and the machine before damage. The safety accessories are blocking accessories,
emergency switches and covers. Check once in a week the function of the safety
accessories. If the safety accessories are functionless, you must stop work and repair or
change the safety accessories.
Enhanced risk!
Do not come into or intervene in the cutting area. Otherwise,
there is possibility of heavy injury.
1.6.1.
Total Stop
TOTAL STOP button is used for emergency switching – off the machine in case defect
or health hazard. By pressing TOTAL STOP button is interrupted the supply of the
electrical power.
If any damages or fault appears, immediately press TOTAL STOP button! Release
the pressing button is possible by twisting of the upper part of the button.
1.6.2.
Arm covers
If the cover is opened during operation, the limit switch is opened and the band saw is
stopped. The band saw is not possible to start in set mode.
The band saw is stated to the operation, when the covers is closed! Limit switche on
saw arm control if cowers are open or not.
1.6.3.
Saw band stretching and rupture inspection
This device checks the saw band stretching and causes immediate machine shut –
down in the event the band ruptures.
11
Advertisement
Table of Contents
