Table of Contents
Advertisement
Note:
When band drive starts, the coolant pump starts automatically
as well. After switching off the band drive, the coolant pump
stops as well.
3.3.2.
Interruption in cutting with Emergency button TOTAL STOP
Picture
3.3.3.
Setting of cutting speed
Saw band speed is changeable between 35 and 70 m.min
Picture
3.3.4.
Angular cut setting
The machine enables angular cuts under 60°. The cut angle can be set fluently
from 0° to 60°.
Picture
Attention!
Turn carefully with saw arm. Do not hit hard on the saw
arm stops for setting 0 ˚ and 60 ˚.
What to do
•
In emergency causes press button Total Stop
•
After pressing Total Stop button the band saw stops
immediately.
-1
.
What to do
•
-1
speed 35 m.min
– turn the speed switch to the
position 1
•
-1
speed 72 m.min
– turn the speed switch to the
position 2
What to do
1.
Release securing lever of the console.
2.
Swivel the frame to the desired angle by pulling the
stretching star. There is a scale on the console.
Note: When adjusting the angle of the cutting, follow the
marking on the console that indicates the current angle on
the scale.
3.
Check the setting according to the scale and tighten
the securing lever of the console
35
Advertisement
Table of Contents
