Table of Contents
Advertisement
3.3.5.
3.4.
3.4.1.
3.4.2.
36
If you can not properly set up mark on console with 0˚ and 60˚ on the scale is
necessary to adjust the screws. By screws adjust properly stops at 0˚ and 60˚.
Optimal adjusting of the guide cubes span
If you want to achieve a smooth and precise cut, it is helpful to position the guide cube
as close as possible to the material.
1.
Release the lever of the left listel and move left part of the
guide apparatus so that the left guide cube edge is as close
to the cut material as possible.
2.
Lower the frame to the lower position and check the
position of the guide cube towards vice loading area. The
guide cube must be a distance of at least 10 mm from the
vice loading area.
3.
Tighten the lever of the gib and check the guide cube setting once more for
possible collision with binding table or vice jaw.
Material insertion
•
Never walk under a suspended load!
•
Never climb onto the gravity-roller conveyor!
•
Do not hold the material for clamping material to the vice! The vice can cause
injury!
Handling agent selection
•
Use the strong handling agents to lift and transfer the material!
•
Handle with the material only with the lift truck or use the suspension strands and
the crane!
•
Do not use the lift truck or crane in case that you do not have the license to handle
with it!
Insertion
Insert material to the vice and ensure that the material cannot move in the vice or fall
from the vice after the clamping. If you cut long pieces of the material (for example rod,
tube), you must use the roller conveyors for material shifting to the band saw. Contact
Bomar for more information about roller conveyors
Make sure the conveyor is long enough and the material cannot tip off the
conveyor.
Be especially careful with round materials that it always stays on two vertical
rollers and that it cannot fall off the conveyor!
Manual version:
1.03/ Feb. 2010
Manual rev.:
1
Advertisement
Table of Contents
