Disconnecting From A Device - Extron electronics AXI 22 AT User Manual

a. Pull — Pulls DSP configuration and preset name data from the device and displays
it in the DSP Configurator workspace. Pulling a configuration overwrites the current
configuration open in DSP Configurator.
b. Push — Pushes the DSP configuration and preset data from the host PC to the
connected device. Pushing a configuration file overwrites any configuration and
presets currently on the device.
Click the Advanced... button to open the Advanced Push Options dialog box.
From this dialog box there are two options to choose from.
1.
2.
4. Click OK. When the push or pull is completed, Current State is displayed in the
DSP Configurator status panel and the device is ready for further configuration.

Disconnecting from a Device

1. Click the Emulate button in the DSP Configurator Software menu bar (see figure 14,
). Alternatively, select Tools>Disconnect from Device or press <F6> on the
1
keyboard.
Figure 14.
2. Click OK to confirm (see figure 15,
Figure 15.
Default — Pushes the entire configuration file including preset data.
Custom — Allows the user to push the configuration only, all presets only, or
selected presets only.
NOTE: If only pushing selected presets, the preset selection dialog box
appears after clicking OK in the Advanced Push Options dialog box.
1
Emulate Button
2
2
Confirm Disconnect Dialog Box
AXI 22 AT and AXI 44 AT • DSP Configurator Software
).
16