Rear Panel Connections - Extron electronics AXI 22 AT User Manual

Rear Panel Connections

POWER
12V
0.5A MAX
A
A
B
C
Figure 3.
A
AT (PoE)
MIC / LINE INS OUTPUTS
1 2 1 2
B C D
12 VDC Power Inlet
Mic/Line Inputs
Line Outputs
AXI 22 AT and AXI 44 AT Rear Panel Connections
12 VDC Power Inlet — As an alternative to PoE, the AXI devices can be powered with
an optional 12 VDC power supply. Connect the power supply to the rear panel power
inlet with a captive screw connector. Plug the power cord into the IEC connector on
the power supply (see figure 4). The power LED on the front panel blinks as the unit is
powering on and lights steadily when the unit is ready for use.
WARNING: The two power cord wires must be kept separate while the
power supply is plugged in. Remove power before wiring.
AVERTISSEMENT : Les deux cordons d'alimentation doivent être tenus à l'écart
l'un de l'autre quand l'alimentation est branchée. Couper l'alimentation avant de
faire l'installation électrique.
ATTENTION:
Do not connect any external power supplies until you have read the
Attention notifications on the next page.
Ne branchez pas de sources d'alimentation externes avant d'avoir lu les
mises en garde de la page suivante.
Rear Panel
Power Receptacle
DC Power Cord
Captive Screw
Connector
Ridged
– Return
+12 VDC input
Smooth
Figure 4. Rear Panel 12 VDC Power Connector
1 2
POWER
12V
3 4
0.6A MAX
R
E A B
AT (PoE) Port
D
Reset Button
E
Ground
all devices.
External
Power Supply
12 VDC, 1.5 A max.
AXI 22 AT and AXI 44 AT • Installation and Operation
1 2
AT (PoE)
3 4
R
C D E
5