Analog Outputs; Renaming At Inputs; Attenuation Dialog Box - Extron electronics AXI 22 AT User Manual

Analog Outputs

The AXI 22 AT has two AT Inputs and two analog line outputs and the AXI 44 AT has four
AT inputs and four analog line outputs. The AXI line outputs are fed by the AT inputs which
receive audio from the Dante network and are listed on the Dante network as Receiver
channels.

Renaming AT Inputs

AT Input channel names are read from the AXI Dante interface Receiver channel labels but
can be changed from the DSP Configurator workspace while connect in Live mode. AT
Input name changes made in DSP Configurator are reflected in Dante Controller and AT
Input name changes made in Dante Controller are reflected in DSP Configurator.
NOTE: AT Input names can only be viewed or changed when connected live to the
To rename an analog output channel:
1.
2.
3.

Attenuation Dialog Box

Double-click the output attenuation block (
configure output attenuation settings.
1
2
3
4
5
6
7
8
device. Default names are always shown when in Emulate mode.
Click the AT Input name, the box becomes a text field with a flashing cursor.
Highlight or delete the text and enter the desired name.
Press <Enter> on the keyboard or navigate away from the text field to apply the new
name. Press the <Down Arrow> key to navigate to and highlight the next name field.
Output Name — This name matches the default or user
defined Dante Receiver channel name.
dBFS Meter — This meter displays the output signal level
in dBFS ranging from -60 dBFS to 0 dBFS. Once the signal
reaches or exceeds -1 dBFS (default) or the clip threshold
defined in the Options dialog box, the clip box located at the
top of the meter lights red. A numerical readout of the output
level is located below the meter.
Output Attenuation Fader — Click and drag the fader to
adjust the attenuation level in 1 dB steps. Click the fader
once and press the <Up Arrow> or <Down Arrow> keys to
adjust the attenuation in 1 dB steps. Use the <Page Up> or
<Page Down> keys to adjust attenuation in 10 dB steps.
Output Attenuation Text Box — Allows the user to enter an
attenuation value in 1 dB steps. The value must be a negative
number.
Mute Button — Mutes the signal at the output stage. When
the button is red, mute is engaged.
OK Button — Confirms changes made to the contained parameters and closes the
Attenuation dialog box.
Cancel Button — Reverts any changes made to the contained parameters back to
their states when the current instance of the Attenuation dialog box was opened and
closes the dialog box.
Attenuation Help Button — Opens the Output Attenuation topic of the DSP
Configurator Help file for further assistance in configuring output attenuation.
) to open the Attenuation dialog box to
AXI 22 AT and AXI 44 AT • DSP Configurator Software
8
1
3
2
4
5
6 7
18