Extron electronics AXI 22 AT User Manual page 39

Command
Network Commands
Set DHCP on
View DHCP status
Set Dante IP/subnet/
gateway
View IP/subnet/
gateway
View MAC address
View Dante device
name
Executive Mode
Set Locked (View Only) 2X
Set Locked
Set Unlocked
View Lock Status
Presets
Recall Preset
NOTE: All variables used on this page are defined on the next page.
ASCII Command
(host to unit)
E }
D1EXPD
E }
DEXPD
E X# X$ X% }
I * * EXPD
E }
IEXPD
E }
HEXPD
E }
NEXPD
1X
0X
X
X(
.
Response
(unit to host)
]
ExpdD1
X1%]
X# X$ X%]
ExpdI * *
X# X$ X%]
* *
X^]
X&]
]
Exe2
]
Exe1
]
Exe0
X*]
X(]
Rpr
AXI 22 AT and AXI 44 AT • Remote Control
Additional Description
E13 is returned if DHCP
is already enabled. DHCP
must be off in order
for this command to be
accepted as valid (DHCP
is enabled by default).
Dante device reboot is also
required for the command
to take effect.
X1%]
ExpdD
(verbose 2 and 3 response)
Using this command
automatically turns DHCP
off. Dante device must
be rebooted for new IP
configuration to take effect
(see the Reboot Dante
device command in the
section above).
X# X$ X%]
ExpdI * *
(verbose 2 and 3 response)
X^]
ExpdH
(verbose 2 and 3 response)
X&]
ExpdN
(verbose 2 and 3 response)
Front panel only displays
settings and status.
Locks all front panel
controls and disables all
status LEDs.
Front panel features are
fully accessible (default).
X*]
Exe
(verbose 2 and 3 response)
33