Disconnecting From A Device - Extron electronics AXI 22 AT User Manual

3. When a connection with the device is established, the
dialog box opens. From the dialog box, one of two options can be selected:
Figure 16.
a. Pull — Pulls DSP configuration and preset name data from the device and displays
it in the DSP Configurator workspace. Pulling a configuration overwrites the current
configuration open in DSP Configurator.
b. Push — Pushes the DSP configuration and preset data from the host PC to the
connected device. Pushing a configuration file overwrites any configuration and
presets currently on the device.
Click the
From this dialog box there are two options to choose from.
1.
2.
4.
Click
OK
DSP Configurator status panel and the device is ready for further configuration.

Disconnecting from a Device

1. Click the
). Alternatively, select
1
keyboard.
Figure 17.
2. Click
OK
Figure 18.
Synchronize with Device Dialog Box
button to open the
Advanced...
Default — Pushes the entire configuration file including preset data.
Custom — Allows the user to push the configuration only, all presets only, or
selected presets only.
NOTE: If only pushing selected presets, the preset selection dialog box
appears after clicking
OK
. When the push or pull is completed,
button in the DSP Configurator Software menu bar (see figure 17,
Emulate
Tools >Disconnect from Device
1
Emulate Button
to confirm (see figure 18,
2
2
Confirm Disconnect Dialog Box
AXI 22 AT and AXI 44 AT • DSP Configurator Software
Synchronize with Device
Advanced Push Options
in the
Advanced Push Options
is displayed in the
Current State
or press
).
dialog box.
dialog box.
on the
<F6>
17