2.6.5
GenSet Information
Displays generator set and controller information.
Displayed data is factory entered.
GenSet Information
GenSet ---->
Information
2.6.6
GenSet Run Time
Displays the generator set's operating record including
total run time loaded and unloaded, number of starts,
and total energy kW hours.
GenSet Run Time
GenSet ---->
Run Time
2.6.7
GenSet System
Display shows the generator set system data including
voltage, frequency, phase connection, etc. Use the
values entered in this menu to help determine shutdown
values and time delays.
The programming user defines the data shown in the
GenSet System menu. It is NOT data measured by the
controller and associated sensing devices.
programming user defines these values for purposes of
calibrating the control.
Some alternators are designed to operate at limited
voltage, frequency, or phase connections and as a result
some settings may have limited parameters.
42
Section 2 Operation
Genset M/N:
##
GenSet S/N:
##
Cntrllr S/N:
##
Eng Runtime:
##.# h
Eng Loaded:
#.# h
Eng Starts:
#
TotalEnergy:
#.# kWh
The
Display for Measurement System is user selectable as
English or Metric.
Contrast display is user adjustable to help improve
digital display visibility in dimly lit rooms or in direct
sunlight.
Note: The contrast feature is a controller hardware
change and may not be available on older units
even if the firmware is updated.
Alarm Silence display is programmer selectable to
Always or Auto Only using SiteTecht software. The
Always selection activates the alarm horn in any of the
OFF/RESET--AUTO--RUN modes.
selection activates the alarm horn only when in the Auto
mode.
GenSet System
GenSet ---->
System
User Selectable - ->
User Selectable - ->
The Auto Only
System Freq:
##.# Hz
SystemPhase:
#####
System Volt:
###.# V
Pwr Rating:
##.# kW
Amp Rating:
##.# A
Power Type:
#####
Battery V:
## V
Meas System
English or Metric
Contrast
#####
AlrmSilence:
Always or Auto Only
TP-6694 7/11