Section 1 Specifications And Features; Introduction; Controller Features - Kohler Decision-Maker 3000 Operation

Industrial generator sets
Hide thumbs Also See for Decision-Maker 3000:
Table of Contents

Advertisement

1.1 Introduction

The spec sheets for each generator set provide model-
specific generator and engine information.
controller spec sheet provides specifications for this
controller. Refer to the respective spec sheet for data
not supplied in this manual. Refer to the generator set
service manual, installation manual, engine operation
manual, and engine service manual for additional
specifications.

1.2 Controller Features

The controller features include the annunciator lamp,
digital display and pushbutton/rotary selector dial,
switches and controls, and fuses and terminal strip. The
following paragraphs detail the features by general
topics.
See Figure 1-1 for an illustration of the controller front
panel.
1
1. Emergency stop switch
2. Generator set master control switches,
OFF/RESET--AUTO--RUN buttons with lamps
3. Digital display
4. Alarm horn (behind panel)
5. Pushbutton/rotary selector dial
Figure 1-1 Decision-Makerr 3000 Controller with Digital Display and Pushbutton/Rotary Selector Dial
TP-6694 7/11

Section 1 Specifications and Features

The controller features, accessories, and menu displays
depend upon the engine electronic control module
(ECM) setup and features. Controller features apply to
The
generator set models with ECM and non-ECM engines
unless otherwise noted.
Note: Press the pushbutton/rotary selector dial to turn
Note: After about 5 minutes of no user input
Note: Measurements display in metric or English units.
2
3
OFF/RESET
AUTO
6. Annunciator fault lamp
7. Controller terminal strips (on circuit board)
8. Alarm silence button with lamp
9. Mini USB connection
on the controller lights and display. The light and
display turn off 60 minutes after the last entry
when in the AUTO mode.
(pushbutton/rotary selector dial or buttons), the
menu is reset to the top of the main menus and
auto-paging
activates
submenus.
Use the Generator Set System menu to change
the measurement display.
4
5
FAULT
RUN
ALARM SILENCE
(press pushbutton/rotary selector dial for lamp test)
Section 1 Specifications and Features
for
the
Overview
6
7
8
9
GM65741-
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents