Mount The Access Point To A Wall Using An Optional Wall And Box Bracket - Extreme Networks ExtremeWireless AP510i Installation Manual

Mount the Access Point to a Wall Using an Optional Wall
and Box Bracket
3. Turn the locking screw into the security screw hole until the security torx locking screw passes
through to the other side and touches the screw stop feature.
Figure 7: Security torx locking screw stop feature
Callout
1

Mount the Access Point to a Wall Using an Optional Wall and Box Bracket

Learn how to install the access point to a wall using the WALL-04 bracket part.
About This Task
Mounting the AP to a flat ceiling requires the WS-MBI-WALL04 (#30516) bracket, two Philips Pan-head
screws, and two screw-in anchors. They must be purchased separately.
Procedure
1. Install the WS-MBI-WALL04 bracket on a wall/ceiling with the two screws and screw-in anchors.
20 ExtremeWireless™ AP510i Access Point Installation Guide
Description
Security torx locking screw stop feature
Note
You cannot remove the access point from the main mounting bracket until the security
torx locking screw is removed.
Note
The locking tab on the WS-MBI-WALL04 bracket must be on the top side during
installation.
Installation Process