Table of Contents
Advertisement
Installation Process
6. Slide the T-bar ceiling mount bracket base into the back of the access point. The locking tab fits into
a groove in the outside of the AP.
Figure 14: Attach the AP unit onto the WS-MBI-DCFLUSH bracket
7. Hold the AP and rock it back and forth to ensure that it is securely mounted.
8. Attach the Ethernet cable's RJ45 connector to the LAN1 port.
9. Place the ceiling tile back in place.
Mount the Access Point Using the WS-MBI-DCMTR01 Bracket
About This Task
The optional WS-MBI-DCMTR01 (#30518) bracket can also be used for T-bar installations without the
mounting bracket.
Before You Begin
•
T-bar width must be 9/16 in. (15 mm), 15/16 in. (24 mm), 1.5 in. (38 mm)
•
T-bar minimum base thickness: N/A; must be structurally sound
•
T-bar maximum base thickness is 0.118 in. (3 mm)
Mount the Access Point Using the WS-MBI-DCMTR01
ExtremeWireless™ AP510i Access Point Installation Guide
Bracket
29
Advertisement
Table of Contents
