Table of Contents
Advertisement
Install the Access Point on a Junction Box or Gang Box
Using the WALL04 Bracket
5. Connect the GE1 cable to the access point.
6. Place the access point onto the bracket feet and slide it down to lock it in place.
Install the Access Point on a Junction Box or Gang Box Using the WALL04 Bracket
Procedure
1. Remove the screws holding the box coverplate.
2. Remove the LAN cable from the coverplate.
3. Place the WALL04 bracket, with the locking tab pointing up, against the mounting holes on the box.
If the WALL04 bracket holes do not align with the mounting holes on the junction or gang box, cut
or enlarge the holes on the WALL04 bracket.
4. Attach the WALL04 bracket to the junction or gang box using the screws removed from the junction
or gang box.
5. Connect the GE1 cable to the access point.
6. Slide the access point on the keyhole slots of the WALL04 bracket until you hear it lock in place.
Install the Access Point on a Beam
Before You Begin
Verify that the:
•
Beam attachment area is at least 0.5 in. (12.7 mm) wide and as long as the largest dimension of the
access point.
•
Beam mounting surface is less than 0.650 in. (16.5 mm) thick.
About This Task
If you do not want to install the access point on a solid flat surface, you can attach it to a beam using
the beam clip accessory (BRKT-000147A-01). The access point can be attached to a beam only if the
beam is flat, and can support the access point in all environmental conditions.
28
ExtremeWireless™ Access Points AP410i/e
Note
The bracket must be square to the rest of the room walls, and the two holes that are being
used must be on the opposite sides of large center hole on the WALL04 bracket.
Caution
Over tightening the screws will cause the WALL04 bracket to bend. If the bracket bends,
you will not be able to align and slide the access point onto the keyhole posts.
Install the Access Point
Advertisement
Table of Contents
