ATEN CN9000 User Manual page 76

CN9000/CN9600/CN9900/CN9950 User Manual
 Stop Bits: This indicates that a character has been transmitted. Set this to
match the stop bit setting of the serial console device. Choices are: 1 and 2.
Default is 1 (which is the default for the majority of serial console
devices).
 Flow Control: This allows you to choose how the data flow will be
controlled. Choices are: None, Hardware, and XON/XOFF. Set this to
match the flow control setting of the serial console device. Default is
None.
Note: None is only supported for baud rates of 9600 and lower. For baud
rates greater than 9600, you must choose Hardware or XON/XOFF.
 Enable Serial Port Bypass: Check/uncheck to enable/disable serial port
bypass. Enabling this function allows the connected DTE device to control
your DCE device (local control) and disables serial console control
(remote control), and vice versa.
A simple diagram explaining the enabling/disabling of serial port bypass is
shown:
Enabling Serial Port Bypass (Local Control)
DCE
Switch
PC
Disabling Serial Port Bypass (Remote Control)
DCE
Switch
PC
64
CN9000/9600/9900/9950
DTE DCE
Serial Console
(Telnet Remote Viewer)
CN9000/9600/9900/9950
DTE DCE
Serial Console
(Telnet Remote Viewer)
DTE
PC
Touch Panel
DTE
PC
Touch Panel