Table of Contents
Advertisement
LDAP Settings
To allow authentication and authorization via LDAP or LDAPS, the Active
Directory's LDAP Schema must be extended so that an extended attribute
name for the CN9600 or CN9000/CN9900/CN9950 – iKVM50-userProfile or
iKVM57-userProfile – is added as an optional attribute to the person class.
Users can find the attribute name of CN9000/CN9600/CN9900/CN9950 by
executing a get command on the Terminal page, see page 38.
In order to configure the LDAP server, you will have to complete the following
procedures: 1) Install the Windows Server Support Tools, 2) install the Active
Directory Schema Snap-in, and 3) extend and update the Active Directory
Schema.
To allow authentication and authorization for the CN9000/CN9600/CN9900/
CN9950 via LDAP / LDAPS, refer to the information in the following table.
Item
Enable
Preferred / Alternate
LDAP
Server IP
Port
Timeout (seconds)
Check Enable to allow LDAP / LDAPS authentication and
authorization.
Click for a drop-down menu to select Preferred LDAP or
Alternate LDAP.
Fill in the IP address and port number for the server. The
default port numbers for LDAP and LDAPS are 389 and 636
respectively.
Set the time in seconds that the CN9000/CN9600/CN9900/
CN9950 waits for an LDAP or LDAPS server reply before it
times out.
Chapter 4. Configuration
Action
49
Advertisement
Table of Contents
