ATEN CN9000 User Manual page 59

 Log Server
Important operations occur on the CN9000/CN9600/CN9900/CN9950, such as
logins and internal status messages, are kept in an automatically generated log
file in the Log Server. See Chapter 9, The Log Server for details on setting up
the log server. The Log File is discussed on page 121.
Check Enable to enable the Log Server function and specify the MAC address
and the Service Port of the computer the Log Server runs on.
The Log Server will listen for log details.
Note: The valid port range is 1–65535. The default port number is 9001. The
port number must different than the one used for the Program port (see
Service Ports, page 42).
 SNMP Trap
To be notified of SNMP trap events, do the following:
1. Check Enable SNMP Agent.
2. Enter the Server IP and the Service Port of the computer to be notified of
SNMP trap events. The valid port range is 1-65535. Default is 162.
Note: The following SNMP trap events are sent: System Power On, Login
Failure, and System Reset.
 Syslog Server
To record all the events that take place on the CN9000/CN9600/CN9900/
CN9950 and write them to a Syslog server, do the following:
1. Check Enable.
2. Enter the Server IP and the Service Port of the Syslog Server. The valid
port range is 1-65535. Default is 514.
Chapter 4. Configuration
47