Table of Contents
Advertisement
CN9000/CN9600/CN9900/CN9950 User Manual
Mouse DynaSync Mode
Clicking this icon selects whether synchronization of the local and
remote mouse pointers is accomplished either automatically or
manually.
The icon on the toolbar indicates the synchronization mode status as follows:
Icon
The green mark on this icon indicates that Mouse DynaSync is
available and is enabled. This is the default setting when Mouse
DynaSync is available.
The red mark on this icon indicates that Mouse DynaSync is
available but is not enabled.
When Mouse DynaSync is available, clicking the icon toggles between enabled
and disabled. If you choose to disable Mouse DynaSync mode, you must use
the manual syncing procedures described in the next section.
Automatic Mouse Synchronization (DynaSync)
Mouse DynaSync provides automatic locked-in synching of the remote and
local mouse pointers – eliminating the need to constantly resync the two
movements.
Manual Mouse Synchronization
If you are using Manual mouse synchronization instead of automatic
DynaSync and the local mouse pointer goes out of sync with the remote
system's mouse pointer, there are a number of methods to bring them back into
sync:
1. Invoke the Adjust Mouse function with the Adjust Mouse hotkeys (see
Adjust mouse, page 86, for details).
2. Move the pointer into all 4 corners of the screen (in any order).
3. Drag the Control Panel to a different position on the screen.
4. Set the mouse speed and acceleration for each problematic computer
attached to the switch. See Additional Mouse Synchronization Procedures,
page 154, for instructions.
104
Function
Advertisement
Table of Contents
