Printing The Measured Results; Saving The Measured Results - TESTO 300 M-I Instruction Manual

Measurement menu
N O N A M E
AT!
F F T T
S S T T A A R R T T
M E M O R Y
The printer
is printing
Measurement menu
E E X X A A M M P P L L E E
AT!
F F T T
M E M O R Y
S S T T A A R R T T
E E X X A A M M P P L L E E
AT!
D D a a t t a a i i s s s s a a v v e e d d
M M E E M M O O R R Y Y
S S T T A A R R T T
3 s
E E X X A A M M P P L L E E
*1
AT!
F F T T
M M E E M M O O R R Y Y
S S T T A A R R T T
The measured values can be transmitted via infrared to the attachable
(testo 300 XL-I only) (Part no. 0554.0570), or the log printer (Part no.
0554.0545). Printing can be activated in the measurement menu by
pressing
be stopped by pressing
If a memory designator is active,
the printout includes the designator.
Date/Time 25.08.1996
"Designator"
Burner 1/15
No. of
No. 3
measurement
Fuel Fuel: light fuel oil
113.4 °C Flue gas temp.
6.5 % O2 level
Measured
values
19ppm CO level
69ppm NO level
If a memory designator is activated, several measurements can be saved
under one designator by pressing the memory button repeatedly.
These measurements are automatically numbered.
If a designator was not selected (See the memory menu in the reference
section) from the selection list, the measured values are saved under
"Noname".
Measurement example

Printing the measured results

. Printing is only possible is the pump is off. Printing can
.
If a memory designator is not active
or is a "noname", the printout is
without "Designator"
10.28

Saving the measured results

20
25.08.1996 10.28
Fuel: light fuel oil
113.4 °C Flue gas temp.
6.5 % O2 level
19ppm CO level
69ppm NO level