Piece Size; Vector; Vector Sorting - Epilog Laser LEGEND 24EX 6000 Owner's Manual

Section 7: Using the Epilog Legend Print

Piece Size

Many users like to create their artwork on a page size in Corel that matches the
size of the piece that is to be lasered. Compensating for beveled edges or placing
an image in an exact location is easy when there is a one-for-one relationship
between the material and the page size of the artwork. If this method works for
you, set the Piece Size dimensions to match the page size you have set in your
graphics software.
On the other hand, many users do not want to change the Piece Size dimensions
every time they print something new. They prefer to use a page size that matches
the table size (32 x20 (812 x 508 mm) for example) and place their artwork into
the upper left corner of the page.
Both methods are effective and it is a matter of personal preference which method
is used.
Generally, jobs will print faster given a smaller page size, even if the size of the
image is the same. To edit the Piece Size click on the underlined numbers to the
right side of "PIECE SIZE:"

Vector

Vector Sorting

A "YES" in the vector sorting box will reorder the sequence of vector cuts. If
sorting is enabled, vectors will cut from the inside out. As an example, if you
have a small circle surrounded by a large circle, the small circle will cut first. If
sorting is disabled, the vectors will cut in the order in which they are presented,
which with most software applications will mean in the order they were drawn.
This definition applies to vector only jobs.
Driver
62