Epilog Laser FiberMark Manual
Optically aligning
Hide thumbs
Also See for FiberMark:
- Manual (9 pages) ,
- Quick start manual (4 pages) ,
- Replacing (3 pages)
Table of Contents
Advertisement
Quick Links
EPILOG LASER
16371 Table Mountain Parkway
Golden, Colorado 80403
Phone 303-277-1188 - FAX 303-277-9669
www.epiloglaser.com
Optically aligning your FiberMark Laser Engraver
Procedure Title:
Tools Needed:
o #1 Phillips Screwdriver (For Side Panel)
o 3/32 Allen Wrench
Supplies provided:
o 1 ea. Alignment Target, provided with machine when new.
WARNING:
o UNDER NO CIRCUMSTANCES ARE YOU TO ATTEMPT TO
OPERATE THE FIBERMARK LASER ENGRAVER WITH THE SIDE
PANELS REMOVED. SERIOUS, PERMANENT EYE DAMAGE MAY
OCCUR.
o LEXAN SAFTEY GLASSES WILL NOT PROTECT YOUR EYES FROM
THE FIBERMARKS LASER BEAM.
Advertisement
Table of Contents
Related Manuals for Epilog Laser FiberMark
Summary of Contents for Epilog Laser FiberMark
- Page 1 1 ea. Alignment Target, provided with machine when new. WARNING: o UNDER NO CIRCUMSTANCES ARE YOU TO ATTEMPT TO OPERATE THE FIBERMARK LASER ENGRAVER WITH THE SIDE PANELS REMOVED. SERIOUS, PERMANENT EYE DAMAGE MAY OCCUR. o LEXAN SAFTEY GLASSES WILL NOT PROTECT YOUR EYES FROM...
- Page 2 Left side of engraver Arrow shows the “Periscope” Diagram 2 7. Reconnect the FiberMark laser engraver to the power source. . 8. Install the Alignment target in the lens carriage...
- Page 3 9. Turn on the engraver 10. Turn on the Red Dot pointer. 11. Depress the “X-Y Off” button on the control panel. 12. Depress the Go button, the carriage can now be moved around the table. 13. Move the X-Axis rail to the rear and the lens carriage to the far left hand side of the engraver.
- Page 4 15. Move the lens carriage to the left side of the X-axis rail and the rail assembly to the front of the engraver. 16. Adjust the Upper Mirror Mount so that the Red Dot pointer is located in the center of the Alignment target.
- Page 5 Carriage Mirror (Mirror 2) Adjustment Diagram: The diagram below illustrates the direction the Red Dot can be expected to move when the indicated mirror adjustment screw is turned. Top Allen Lower right Lower left screw turned Allen screw Allen screw clockwise turned clockwise turned clockwise...
- Page 6 Red Dot image stays in the center of the target. 36. You have now completed the Updating your FiberMark Optics. If you have any questions please call Epilog’s Technical Support Phone 303.215.9171...
Need help?
Do you have a question about the FiberMark and is the answer not in the manual?
Questions and answers