Epilog Laser LEGEND 24EX 6000 Owner's Manual page 228

Appendix C
Printing From AutoCAD
The Pen default
setting is 0.010
inch. The first time
that you print to the
Legend you will
need to set Pens 1-
11 to 0.001 inch.
Select pens 1-11
and change the
Width value to
0.001. Click OK.
Note This is a very
important step in the process of vector cutting from AutoCAD. A pen width of 0.010
will not provide a vector command to the Legend laser system and there will be no
output from the laser.
After returning to the
Print/Plot
Configuration
window, click on the
Device and Default
Selection tab to begin
accessing the Legend
print driver.
214