Epilog Laser LEGEND 24EX 6000 Owner's Manual page 130

Section 10: Material Engraving Techniques
a side view of the difference in characters when their widening set to 1 or 6. Many
users feel the default setting of 1 is ideal.
Stamp Match: The last setting that you may need to make is on the Legend control
panel under Service | Calibrate | Stamp Match. The Stamp Match setting is
defaulted to 50 which is ideal for most stamp applications. If you notice that there is
a little jaggedness at the edges of your stamp letters, adjust the Stamp Match by one
or two digits (either up to 51 or 52, or down to 49 or 48 etc). This feature fine tunes
the left to right alignment of each raster line and should straighten out any rough
edges that may appear.
116