Configuring Coreldraw; Print Settings Within Corel 9 Or Corel Essentials - Epilog Laser LEGEND 24EX 6000 Owner's Manual

Section 5: Configuring
In This Section
Print Settings within CorelDraw 10
Color Mapping
Installing and Using the WIN XP/2000 EX Print Driver with Corel 9
Many Legend users use Corel 9 or Corel Essentials as their drawing software
package. Corel 9 and Corel Essentials are essentially the same software, with
only very minor differences between the two. You will limit the number of
printing problems and get the most out of your laser if you make the following
settings changes in CorelDraw 9 and Corel Essentials.
Print Settings within Corel 9 or Corel
Essentials
1.
2.
3.
4.
5.
6.
7.
8.
9.
CorelDraw
Open CorelDRAW
Place something on the page or open a file. Print preview in step 4 will not
be available if the page in Corel is blank.
Click on pull down menu FILE
Select PRINT PREVIEW
Click on pull down menu SETTINGS
Select PRINTING PREFERENCES
Select DRIVER COMPATIBILITY from the tree
Select the "Legend Engraver EX Win32" as the printer
Under settings specific to this driver, uncheck all of the boxes next to the
settings below:
All text as graphics
Use software clipping for fills
Output bitmaps in 64 chunks
Send beziers and paths to driver
Send bands to driver
Use color profile for composite
41