ID50 Series Panel - Installation, Commissioning & Configuration Manual
[Sensor nn - AVS]
1 : Alarm(L5,5)
2 : Day(L5,5)
AVS Group
The AVSGroup option is used to associate a number of
either AVS or AVR sensors in up to a maximum of 50
groups, see Section Co-operative Multi-Sensing. The
operation of VIEW
follows:
a. VIEW
b. In a group containing both types, the AVSs desensitise
c. In a group containing AVS type sensors, all sensors
Note: One or more AVRs may be configured in a group.
To assign a sensor to a group:
1 From the VIEW
Sensitivity
3 : AVSGroup(01)
2 The LCD prompts for a new AVS Group number. Use
3
[Sensor nn - AVS]
Enter new AVS Group : ____
3 The LCD then returns to the previous display.
[Sensor nn - AVS]
1 : Alarm(L5,5)
A2.4 Automatically Learning VIEW
When automatically learning an SLC Loop including
VIEW
type. The LCD shows the total number of these sensors,
as in the example below:
[Learn]
Any sensors that need to be configured to an AVR type
must be changed individually, see Section A2.2,
Learning Individual VIEW
A2 - 5
sensors assigned to a group is as
TM
sensors operate independently if the sensor
TM
is assigned to group 0.
if AVRs detect a sudden rise in contaminated air.
operate as standard VIEW
sensor Sensitivity menu, using the
TM
numeric keypad press
3
option.
the numeric keypad to enter the required group
number and press
to confirm.
5
Sensitivity
< : Cancel
Sensitivity
2 : Day(L5,5)
3 : AVSGroup(01)
sensors, each sensor is configured as an AVS
TM
TOTAL ION OPT TMP MLT AVS
68
10
20
TM
sensors.
TM
to access the AVSGroup
Sensors
TM
25
05
08
Sensors.
997-263, Issue 4
September 2002