Ancillary Functions - Notifier ID50 Installation, Commissioning & Configuration Manual

ID50 Series Panel - Installation, Commissioning & Configuration Manual
997-263, Issue 4
September 2002

1.6 Ancillary Functions

The following is a list of ancillary functions that are
provided by the ID50 Series panel in addition to the those
required by EN54-2/4. These functions are described in
the section of this manual as referenced (except those
marked thus ‘ * ’ which are described in 997-264-XXX,
ID50 Series Panel - Operating Manual):
Ancillary
Functions
Site Specific Setup Options
Access Options
Voltage Indications
Control-by-Event
Output modes
Input type pattern
Disable/enablement
Repeater interface
Self-learn configuration - manual
Self-learn configuration - auto
Module supervision options
Module silence options
Text editing
Sensor LED blinking on/off
Bell pulsing ratio
Display of alarm count
Extend delay timer
Sounder Volt-free contact options
Relay drive output option
Extinguishing system features
4
Manual
Section Refs.
5.5
5.9
*4.11.7
5.7
5.7.1
5.7.9
*4.9
2.7
5.6.1
5.6.2
5.6.1
5.7.4
5.8
5.5.7
5.5.8
*4.11.6
5.5.3
4.4.5
4.4.6
5.5.4, 5.5.5, 5.5.6,
5.7.1