Notifier ID50 Installation, Commissioning & Configuration Manual page 47

ID50 Series Panel - Installation, Commissioning & Configuration Manual
1
or
2 8
6
5.5.6 Hold Switch Operation
AUX modules, configured as one of four Hold Switch
categories, can be used to affect the Extinguishing
System Delay timer function. The four categories are:
AHJ - While this input is active, the Extinguishing System
Delay timer is reset to the configured value and paused.
NYC - While this input is active, the Extinguishing
System Delay timer is reset to the configured value
plus 90 secs and paused.
ULI - While active, the Extinguishing System Delay
timer continues to count down but pauses at 10 secs
before release.
IRI - Hold switch activity is ignored if two or more
zones associated with CBE rules with a category of
‘Extinguishing System’ are in alarm. Otherwise
operation is the same as type ULI.
Note: Only one of the above Hold Switch input types may
be used per panel.
1 From the Commissioning menu, press the ‘
on the numeric keypad to enter the Setup menu.
[Setup] Language =
> : Change
2 Press the ‘ /
2
menus until the LCD shows the Hold Switch Operation
menu.
[Setup] Hold Switch Operation =
> : Change
3 Press the ‘ ’ button to select alternative settings of
6
NYC, ULI or IRI, as required. Changing the setting
saves the change automatically.
Note: The default selection is AHJ.
5.5.7 Device Blinking
The Device Blinking option configures the LED’s of
sensors and modules on the SLC Loop to blink or not
when polled. To configure this option:
1 From the Commissioning menu, press the ‘
on the numeric keypad to enter the Setup menu.
[Setup] Language =
> : Change
2 Press the ‘ /
2
menus until the LCD shows the Device Blinking menu.
[Setup] Device Blinking = ON
> : Change
3 Press the ‘ ’ button to select the required setting,
6
either ON or OFF.
[Setup] Device Blinking = OFF
> : Change
4 Press ‘ ’ to return to the Commissioning menu.
4
41
English
× : More < : Exit
’ buttons to step through the Setup
8
AHJ
× : More < : Exit
English
× : More < : Exit
’ buttons to step through the Setup
8
× : More < : Exit
× : More < : Exit
997-263, Issue 4
September 2002
’ button
1
’ button
1