Notifier ID50 Installation, Commissioning & Configuration Manual page 48

ID50 Series Panel - Installation, Commissioning & Configuration Manual
1
or
2
6
1
or
2
6
997-263, Issue 4
September 2002
5.5.8 Pulse On/Off Ratio
The Pulse On/Off Ratio option is used to set the sounder
output pulse ratio to either 1/1 or 4/1. To configure the
ratio:
1 From the Commissioning menu, use the numeric keypad
and press the ‘
[Setup] Language =
> : Change
8
2 Press the ‘
menus until the LCD shows the Pulse On/Off Ratio
menu.
[Setup]
> : Change
3 Press the ‘
to either 1/1 or 4/1.
[Setup]
> : Change
4 Press ‘
5.5.9 Service Phone Number
This option allows a service contact phone number to be
displayed with fault messages. To enter or change the
number:
1 From the Commissioning menu, press the ‘
on the numeric keypad to enter the Setup menu.
[Setup] Language =
> : Change
8
2 Press the ‘
menus until the Service Phone Number menu is
displayed.
[Setup]
> : Change
3 Press the ‘
The existing 20-characters of text are shown on the upper
line. The current cursor position is indicated by a flashing
character. Enter the required telephone number via the
numeric keypad or use the ‘
through the available alphanumeric characters.
[
> : Next
Note: For further information on how to edit text, refer to
4 Press the ‘
Setup menu.
42
’ button to enter the Setup menu.
1
English
× : More
/ ’ buttons to step through the Setup
2 8
Pulse On/Off ratio = 1/1
× : More
’ button to change the required setting
6
Pulse On/Off ratio = 4/1
× : More
’ to return to the Commissioning menu.
4
English
× : More
/ ’ buttons to step through the Setup
2 8
Phone = < blank/existing text
× : More
’ button to enter the text editing menu.
6
] × : Char
< : Previous u1:Delete
Section 5.8, Zone Texts.
’ button to confirm and return to the
5
< : Exit
< : Exit
< : Exit
’ button
1
< : Exit
>
< : Exit
/ ’ buttons to scroll
2 8
3
: Done
u3:Insert