Notifier ID50 Installation, Commissioning & Configuration Manual page 50

ID50 Series Panel - Installation, Commissioning & Configuration Manual
997-263, Issue 4
September 2002
5.5.12 RS232 Protocol
This option enables the protocol of the RS232 port to be
configured for use with either driver:
a. External printer (default selection).
b. Third party equipment.
1 From the Commissioning menu, press the ‘
on the numeric keypad to enter the Setup menu.
[Setup] Language =
> : Change
2 Press the ‘ /
2 8
menu until the RS232 Protocol menu is displayed.
[Setup] RS232 Protocol =
> : Change
3 Press the ‘ ’ button to toggle between ‘PRINTER’
6
and ‘THIRD PARTY’.
4 Press ‘ ’ to return to the Commissioning menu.
4
5.5.13 Print Control or Third Party
This option is dependent upon the selected RS232
operating mode (see Section 5.5.12).
If the RS232 port is set to PRINTER, the available ‘Print
Control’ options are:
a. BASIC - slow mode, no handshaking (default option).
b. XON/XOFF handshaking.
If the RS232 port is set to THIRD PARTY, the available
‘Third Party’ options are:
c. Full duplex (default option).
d. Half duplex.
1 From the Commissioning menu, press the ‘
on the numeric keypad to enter the Setup menu.
[Setup] Language =
> : Change
2 Press the ‘ /
2 8
menu until the Print Control/Third Party menu is
displayed.
[Setup] Print Control =
> : Change
[Setup] Third Party =
> : Change
3 Press the ‘ ’ button to toggle between ‘BASIC’ and
6
‘XON/XOFF’, or ‘FULL DUPLEX’ and ‘HALF DUPLEX’.
4 Press ‘ ’ to return to the Commissioning menu.
4
44
1
English
× : More < : Exit
’ buttons to scroll through the Setup
PRINTER
× : More < : Exit
1
English
× : More < : Exit
’ buttons to scroll through the Setup
BASIC
× : More < : Exit
FULL DUPLEX
× : More < : Exit
’ button
’ button