Ce Marking; En54 Functions - Notifier ID50 Installation, Commissioning & Configuration Manual

ID50 Series Panel - Installation, Commissioning & Configuration Manual

1.4 CE Marking

This panel is CE Marked to show that it conforms to the
requirements of the following European Community
Directives:
n
Electromagnetic Compatibility Directive 89/336/EEC
(and the amending Directives 92/31/EEC, 93/68/EEC)
n
Low Voltage Directive 73/23/EEC (and the amending
Directive 93/68/EEC).

1.5 EN54 Functions

This fire control panel is designed to comply with the
requirements of EN 54 Part 2/4: 1997. In addition to the
basic requirements of EN 54-2, the panel may be configured
to conform with the following optional functions - the
applicable clauses of EN 54-2 are referenced as follows:
Options
Indications:
Fault signals from points
Recording of the number of entries
into fire alarm condition
Controls:
Coincidence detection
Delay of the immediate actioning of outputs
Disablement of each address point
Test condition
Outputs:
Fire alarm device(s) (Sounders)
Fire alarm routing equipment
Fire protection equipment
Fault warning routing equipment
(requires monitoring by fault routing equipment)
The following features are provided by the Power Supply
Unit (PSU) of the ID50 Series Panel to comply with
EN 54-4.
Features of the ID50
Power Supply Unit (PSU)
Derive power from the mains supply
Derive power from a standby battery source
Charge and monitor the standby
battery/batteries
Detect and signal various PSU faults
3
Clause
8.3
7.13
7.12
7.11
9.5
10
7.8
7.9
7.10
8.9
EN54-4
Clause
5.1
5.2
5.3
5.4
997-263, Issue 4
September 2002