Notifier ID50 Installation, Commissioning & Configuration Manual page 54

ID50 Series Panel - Installation, Commissioning & Configuration Manual
1
or
2
6
1
997-263, Issue 4
September 2002
5.5.19 Day Mode Activity
The Day mode function enables the panel to switch
between two (2) preset sensitivity levels. Day mode is
set for one time period per day for seven days unless the
Weekend night mode is also configured (Section 5.5.20,
Weekend night mode). It also allows the manual
activation/deactivation of delayed outputs during the set
Day mode period. To configure the Day mode period:
1 From the Commissioning menu, using the numeric
keypad press the ‘
[Setup] Language =
> : Change
2 Press the ‘
8
menu until the Day mode activity menu is displayed.
[Setup]
> : Change
3 Press the ‘
which this function will be enabled.
[Setup]
Enter start time :
4 Using the numeric keypad, enter the appropriate time
in the 24-hour clock format and confirm using the ‘
button.
[Setup]
Enter start time :
5 The LCD displays a prompt to enter an end Day mode
time. Use the numeric keypad to enter the appropriate
time in the 24-hour clock format and confirm using
the ‘
[Setup]
Enter finish time :
[Setup]
> : Change
6 Press ‘
Commissioning menu.
To disable Day mode
1 With the Day mode activity menu displayed, press the
‘
[Setup]
> : Change
[Setup]
> : Change
2 Press ‘
menu.
48
’ button to enter the Setup menu.
1
English
× : More
/ ’ buttons to step through the Setup
2 8
Day mode activity = DISABLED
1 : Disable × : More
’ button to prompt for a start time at
6
Day mode activity = DISABLED
-0:00
Day mode activity = DISABLED
07:46
’ button.
5
Day mode activity = DISABLED
-0:00
Day mode activity = 07:46-> 18:12
1 : Disable × : More
’ to save all changes and return to the main
4
’ button on the numeric keypad.
1
Day mode activity = 07:46-> 18:12
1 : Disable × : More
Day mode activity = DISABLED
1 : Disable × : More
’ to exit and return to the Commissioning
4
< : Exit
< : Exit
< : Cancel
’
5
< : Cancel
< : Cancel
< : Exit
< : Exit
< : Exit