Locate A Problem With Basic Printer Functions - Entrust EM1 User Manual

Locate a Problem with Basic Printer Functions

If the system is not working as expected, follow these steps in the order listed to isolate the
source of the problem before you contact your service provider.
1.
Make sure that the power cord is plugged in and the printer is powered on.
2.
Does the printer power on and the U
If the printer powers on correctly, continue to

If the printer powers on, but an Improper Shutdown condition is issued, press the U

button for approximately 2 seconds. T
If the printer powers on but the U

working properly. Request service for the printer.
If the printer does not power on, make sure that the printer power supply is working

properly.
If the power supply is working properly, request service for the printer from your

system administrator.
If the power supply is not functioning, replace it and begin with

3.
Print a test card from the printer front panel. Refer to
Address" on
If the test card prints, the printer is working correctly. Continue to

If the test card does not print, the printer is not working correctly. Request service for the

printer.
4.
Connect the printer data cable, if necessary. Make sure that you use the same type of cable
(USB or network) used when the printer was installed.
5.
If you use the XPS Card Printer Driver, print a driver sample card. For the steps to follow, refer
to the XPS Card Printer Driver User's Guide.
If the sample card prints, the printer and driver are working correctly. Continue to

If the sample card does not print, the printer and driver have a communication problem.

Determine the cause of the problem and try the sample card again.
If you do not use the Card Printer Driver, ask your service provider or software provider for
assistance.
EM1, EM2 Card Printers User's Guide
page 15 for more information.
button light solid green?
SER
step 3.
U button should light solid green.
HE SER
button does not light solid green, the printer is not
SER
"Print a Test Card with Network IP
SER
step 1.
step 4.
step 6.
33