Technical Limit Values; Warranty Prevision; Use Of Instruction; Operator Liability - ABB 2600T Series Instruction Manual

2 6 0 0 T S E R I E S | P R E S S U R E T R A N S M I T T E R S | O I/ 2 6 6/ F F - E N R E V. E

Technical limit values

The device is designed for use exclusively within the values
stated on the name plates and within the technical limit values
specified on the data sheets.
The following technical limit values must be observed:
• The Maximum Working Pressure may not be exceeded.
• The Maximum ambient operating temperature may not be
exceeded.
• The Maximum process temperature may not be exceeded.
• The housing protection type must be observed.

Warranty prevision

Using the device in a manner that does not fall within the scope
of its intended use, disregarding this manual, using
underqualified personnel, or making unauthorized alterations,
releases the manufacturer from any liability for any resulting
damage. This makes the manufacturer's warranty null and void.

Use of instruction

The symbols used in this document are explained below:
DANGER
The signal word 'DANGER' indicates an imminent danger.
Failure to observe this information will result in death or
severe injury.
WARNING
The signal word 'WARNING' indicates an imminent danger.
Failure to observe this information may result in death or
severe injury.
CAUTION
The signal word 'CAUTION' indicates an imminent danger.
Failure to observe this information may result in minor or
moderate injury.
NOTICE
The signal word 'NOTICE' indicates potential damage to
material or its surrounding area.
IMPORTANT
This message indicates operator tips or particularly useful
information. It does not indicate a dangerous or damaging
situation.

Operator liability

Prior to using corrosive and abrasive materials for measurement
purposes, the operator must check the level of resistance of all
parts coming into contact with the materials to be measured.
ABB will gladly support you in selecting the materials, but
cannot accept any liability in doing so.
The operators must strictly observe the applicable national
regulations with regard to installation, function tests, repairs,
and maintenance of electrical devices.

Qualified personnel

Installation, commissioning, and maintenance of the device
may only be performed by trained specialist personnel who
have been authorized by the plant operator. The specialist
personnel must have read and understood the manual and
comply with its instructions.

Returning devices

Use the original packaging or suitably secure shipping package
if you need to return the device for repair or recalibration
purposes. Fill out the return form (see the end of the document)
and include this with the device.
According to EC guidelines and other local laws for hazardous
materials, the owner of hazardous waste is responsible for its
disposal. The owner must observe the proper regulations for
shipping purposes.
All devices sent back to ABB must be free from any hazardous
materials (acids, alkalis, solvents, etc.).

Disposal

ABB actively promotes environmental awareness and has an
operational management system that meets the requirements
of DIN EN ISO 9001:2000, EN ISO 14001:2004, and OHSAS
18001. Our products and solutions are intended to have
minimum impact on the environment and persons during
manufacturing, storage, transport, use and disposal.
This includes the environmentally friendly use of natural
resources. ABB conducts an open dialog with the public
through its publications.
This product/solution is manufactured from materials that can
be reused by specialist recycling companies.

Information on WEEE Directive 2012/19/EU

This product or solution is subject to the WEEE Directive
2012/19/EU (Waste Electrical and Electronic Equipment) or
corresponding national laws. Starting from August 15th 2018,
electrical and electronic equipment marked with the crossed-
out wheeled bin symbol may not be disposed as unsorted
municipal waste. Waste of electrical and electronic equipment
(WEEE) shall be treated separately using the national collection
framework available to customers for the return, recycling and
treatment of WEEE.
5