Fcc Notices; Fcc-Approved Antennas - Digi ConnectCore 8X Hardware Reference Manual

Regulatory information and certifications
Peak
RF antenna
band gain
5 GHz 4.6 dBi

FCC notices

IMPORTANT: The ConnectCore 8X module has been certified by the FCC for use with other products
without any further certification (as per FCC section 2.1091). Modifications not expressly approved by
Digi could void the user's authority to operate the equipment.
IMPORTANT: OEMs must test final product to comply with unintentional radiators (FCC section 15.107
& 15.109) before declaring compliance of their final product to Part 15 of the FCC Rules.
IMPORTANT: The ConnectCore 8X module has been certified for remote and base radio applications.
If the module will be used for portable applications, the device must undergo SAR testing. This
equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: Re-orient or
relocate the receiving antenna, Increase the separation between the equipment and receiver, Connect
equipment and receiver to outlets on different circuits, or Consult the dealer or an experienced
radio/TV technician for help.
IMPORTANT: This module has been tested and found to comply with the following requirements
for Modular Approval.
Part 15.247 - Operation within the bands 902-928 MHz, 2400-2483.5 MHz, and 5725-5850 MHz.
Part 15.407 – General technical requirements.

FCC-approved antennas

The ConnectCore 8X module can be installed utilizing antennas and cables constructed with non-
standard connectors (RPSMA, RPTNC, and so on).
The modules are FCC approved for fixed base station and mobile applications for the channels
indicated in the tables below. If the antenna is mounted at least 20 cm (8 in) from nearby persons, the
application is considered a mobile application. Antennas not listed in the table must be tested to
comply with FCC Section 15.203 (Unique Antenna Connectors) and Section 15.247 (Emissions).
ConnectCore® 8X System-on-Module Hardware Reference Manual
Channel
Technology bandwidth
WLAN 20
40
80
Channel number (Center frequency, MHz)
36(5180), 40(5200), 44(5220), 48(5240), 52
(5260), 56(5280), 60(5300), 64 (5320), 100(5500),
104(5520), 108(5540), 112(5560), 116(5580), 120
(5600), 124(5620), 128(5640), 132(5660), 136
(5680), 140(5700), 149 (5745), 153(5765), 157
(5785), 161(5805), 165(5825)
38(5190), 46(5230), 54(5270), 62(5310), 102
(5510), 110(5550), 118(5590), 126(5630), 134
(5670), 151(5755), 159(5795)
42(5210), 58(5290), 106(5530), 122(5610), 155
(5775)
United States FCC
108